Vehicle body paint, metal components, headlights and taillights, tires, and rims.
Applying it to a mid-size car takes about 15–20 minutes. Before application, wash the vehicle with The Detail Dr’s Molecular Bath thoroughly to eliminate dust, oil, grease, and other residues. There is no need to dry the surface with a cloth afterward; simply allow the water to drain for 5–6 seconds. On areas where water doesn’t run off easily, such as the roof, gently remove the excess water with a cloth without fully drying the surface.
Shake the bottle gently before use. Spray about 10–15 times per square meter (8–10 mL is enough for 1 m² — ensure that a sufficient amount of product reaches the surface) and immediately wipe it with a dry, lint-free drying towel or a microfiber cloth using circular motions and light pressure until the surface becomes dry and streak-free. If the microfiber becomes too wet, wring it out or replace it. Avoid wiping the surface with a damp cloth, as this may lead to spotting. Dispose of the towel after use.
The product begins to show its effect after two hours. For best results, keep the coated area away from water for 4 hours and avoid washing with detergent for 24 hours.
Do not let the product sit on the surface; wiping must be done right after spraying. If the application is done incorrectly, removal can only be achieved using a medium-cut polishing compound.
